Things to be aware of when using the shearing machine

1. The shearing machine should have a dedicated person responsible for use and storage. The operator must be familiar with the structure and performance of the machine.

2.  It is strictly forbidden to use shearing machine for overload, and it  is not allowed to shear hardened steel and hard steel, high speed steel,  alloy steel, casting and non-metal materials.

3, the blade edge should be sharp, the edge is blunt or damaged, should be repaired or replaced in time.

4, multi-person operation should have a special person command, coordination should be coordinated.

5. It is forbidden to cut two different specifications of materials at the same time on the shearing machine.

6. When the cutting board is feeding, it is forbidden to promote the operation under the pressure plate. When  cutting short materials, use another iron plate to press it. When  cutting, the finger should be at least 200 mm away from the edge.

7.  After holding the line, you should immediately remove the 撬 方 to cut,  such as the iron plate has moved, apply the wooden pillow to plug, so as  not to press the foot down and hold the wound.

8. The cut workpieces must be placed in a stable position, not stacked too high, and not allowed to be stacked on the aisle. The corners and scraps should be cleaned up in time to keep the site clean and tidy.

9. The safe operation of the bending machine is subject to this regulation.